Correct Use - IKA RW 47 digital Kurzanleitung

• Use
For mixing/stirring liquids with low to high vis-
cosity by using various stirring tools.
Intended use: Stand device (Chuck downward).
• Range of use (indoor use only)
- Laboratories - Technical colleges
- Pharmacies - Small-scale production
The overhead stirrer RW 47 digital must be se-
cured to a stable stand (e.g. R 474 or R 472) with
four screws and wired according to the wiring dia-
gram for proper use. The stirring vessel must al-
ways be well secured for safety reasons. You must
also ensure that the mounting equipment (e.g.
floor stand, telescope stand) is set up in such a
way that it is not liable to topple and does not start
to move during the stirring procedure. Accessories
must be assembled and wired according to the as-
sembly instructions (Fig. 3 to Fig. 7).

Correct use

This equipment is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to low-voltage
supply network that also supplies residential areas.
The safety of the user cannot be guaranteed:
- If the instrument is operated with accessories
that are not supplied or recommended by the
manufacturer
- If the instrument is operated improperly contrary
to the manufacturer's specifications
- If the instrument or the printed circuit board are
modified by third parties.
Commissioning
If the stirring unit is operated in such a way that the
instrument's OFF switch (B, see Fig. 1) is not ac-
cessible, you must add an another EMERGENCY
STOP switch to the work area so that it can be
easily reached.
Points of particular danger (such as crushing, rotat-
ing parts, clamping screws for stand legs and roll-
ers etc.) are marked in Fig. 8 with an exclamation
mark. Please pay particular attention to these danger
points during operation!
If above conditions are
met, the instrument is
ready for operation after
plugging in the mains plug.
14