Timago CLASSIC-TIM Benutzerhandbuch Seite 31

• The wheelchair was op�onally equipped with pneuma�c rear wheels 24''
in diameter and swivel, PU front wheels 8'' in diameter (tubeless tyre).
Remember to control the air pressure in both wheels and check the
condi�on of the tyres in search of abrasions, cuts or surface deple�on.
• To balance the air pressure in the wheels, twist off the cap of the valve,
insert the pump (included in the set) into the valve, and pump the air.
WHEEL LOCKS
• To lock the wheels, push the lock lever forwards un�l the wheel is fully
blocked (separately for le� and right wheel). Please, note that the wheel
lock only serves to lock the wheels when the wheelchair is at a complete
stop.
WHEEL LOCKS ADJUSTMENT
The correct lock of the wheel lock depends on its adjustment and posi�on. The
handle of the wheel lock should be posi�oned so that the wheel lock shoe blocks
the wheel firmly and the lever does not face excessive resistance.
• In case of excessive resistance, pull the handle forwards slightly by twis�ng
off the locking screw which is located on the other side of the wheel lock
(from the inside of the wheelchair). Set the wheel lock shoe in such posi�on
that the wheel lock blocks the wheel easily and without resistance.
• When the wheel lock shoe does not touch or block the wheel sufficiently,
follow the above instruc�on by moving the handle in the opposite direc�on.
SEAT BELTS
The belt, which is included in the standard equipment, protects the trunk in cases
when the user slides down from the wheelchair or is not able to keep correct
posi�on independently. The belt is fastened with the use of buckle.
4. Technical data
Overall width
Overall depth
Seat height from the ground
Overall height
Inner width 43, 46, 48, 51 cm
91 cm (88 cm)
31
57-67 cm
104 cm
50 cm