Timago CLASSIC-TIM Benutzerhandbuch Seite 30

3. Assembly
UNFOLDING AND ASSEMBLY
Step 1. Unfolding the wheelchair
Place the wheelchair on the ground. Unfold the wheelchair by using the hand
grips which are at the back of the backrest. Then, press the front and rear edge of
the seat so that all the elements fit together.
Step 2. Assembly of footrests
Assemble the right and the le� footrest in the front part of the frame by placing
them on two pins and turn them inwards un�l they are locked.
Step 3. Adjustment of footplates
Adjust the right and the le� footplate with the use of pins and locking clips which
is placed on the footrest. In case of eleva�ng legrest, adjust the angle of
inclina�on to the ground using the lever. Proper space should be le� between the
footplates and the ground as footplates set too low may cause difficul�es in
overcoming such obstruc�ons as curb. Adjust the footplates so that the angle
between trunk and thighs is 90
then).
Step 4. Assembly of protec�ve strap
Put the protec�ve strap on the footrests as it prevents user's legs from sliding
down under the wheelchair from footplates.
Note! Do not use the wheelchair without protec�ve strap.
On comple�on of the above ac�vi�es, the wheelchair is ready to use.
FOLDING
The wheelchair can be re-folded in order to be transported and stored more
easily.
• Before folding the frame, swing away the footplates and set them in ver�cal
posi�on (perpendicularly to the ground).
• To fold the frame, pull the seat upwards by holding the front and the back
edge in the middle, so that the frame jumps out from the connec�ng
elements.
FLIP-UP FUNCTION OF ARMRESTS
• Press the locking buton located in the front part of the armrest and push
the armrest backwards.
• To close the armrest, push it downwards so that the locking buton clicks.
PUMPING THE WHEELS
(op�mum si�ng posi�on is provided to the user,
0
30