Installation (10011487) - Klarstein Rc90Ws Bedienungsanleitung

EN
28
28

INSTALLATION (10011487)

INSTALLATION
1. The distance between the cooking surface and the lowest edge of the cooker
The distance between the cooking surface and the lowest edge of the cooker
hood must be at least 65 cm (see picture 1).
hood must be at least 65 cm (see picture 1).
2. Once the height is defined, install the anchoring in the appropriate place. To
Once the height is defined, install the anchoring in the appropriate
2.
do this, you must first drill holes (you will need a drill, suitable drill bits, dowels
do this, you must first drill holes (you will need a drill, suitable drill bits, dowels
and screws) and then fix the anchorage to the wall with the screws. After the
and screws) and then fix the anchorage to the wall with the screws. After the
anchoring is fixed, use the similar procedure to attach the internal clamp for
anchoring is fixed, use the similar procedure to attach the internal clamp for
the fireplace facing (see Figure 2). Please pay attention to the correct distance
the fireplace facing (see Figure 2). Please pay attention to the correct distance
(please measure the distance), because the fireplace facing will be fixed to the
(please measure the distance), because the fireplace facing will be fixed to the
bracket later.
bracket later.
3. Please fix the outside clamp for the fireplace facing to the outside of the facing
3. Please fix the outside clamp for the fireplace facing to the outside of the facing
and check if the inside fireplace facing is free to move in height. Next, install
and check if the inside fireplace facing is free to move in height. Next, install
the pipe connection and the chimney facing on the hood. Refer to Figure 3.
the pipe connection and the chimney facing on the hood. Refer to Figure 3.
4. Place the hood on the anchorage (see Figure 4). 5.
4. Place the hood on the anchorage (see Figure 4). 5.
5. Set the correct height of the inner chimney facing so that the brackets match
5. Set the correct height of the inner chimney facing so that the brackets match
and fix them. After that you can fix the hood with the safety screws(see picture
and fix them. After that you can fix the hood with the safety screws(see picture
5).
5).
Note: Please note that the two safety caps are located on the back of the casing.
Note: Please note that the two safety caps are located on the back of the casing
1
1
752m
(10011487)
place. To
2
2
Inside chimney bracket
Inside chimney bracket
Hook
Hook