Instant Pot Duo mini v3 Benutzerhandbuch Seite 40

Troubleshooting
Problem
Steam leaks from side
of lid.
The float valve does
not rise.
Small amount of steam
leaking/hissing from the
steam release handle
during the cooking cycle.
40 | support@instantpot.co.uk | +44 (0) 3331 230051
Duo-UK-ENG-Full_Manual-2021-03-03.indd 40 Duo-UK-ENG-Full_Manual-2021-03-03.indd 40
Possible reason
No sealing ring in the lid.
The sealing ring is damaged or not
properly fitted.
Food debris attached to the
sealing ring.
The lid is not closed properly.
The sealing ring rack is warped or
off-centre.
The inner pot rim may be misshapen.
Food debris on the float valve or
float valve silicone cap.
Too little liquid in the inner pot.
Float valve silicone cap damaged or
missing.
Float valve obstructed by lid-locking
mechanism.
No heat in the inner pot.
Inner pot base may be damaged.
Steam release handle is not in the
Sealing position.
Multicooker is regulating
excess pressure.
Try this
Fit a sealing ring.
Replace the sealing ring.
Remove the sealing ring and clean it
thoroughly.
Open, then close the lid.
Remove the sealing ring from the lid, then
check the sealing ring rack for bends or
warps. Contact Customer Care.
Check for deformation and contact
Customer Care.
Remove the float valve from the lid and clean
it thoroughly. Perform the Initial test run to
check operation and record your findings.
Contact Customer Care.
Check for scorching on the bottom of the
inner pot. Add thin, water-based liquid to the
inner pot according to its size.
3 L: 250 mL
5.7 L: 375 mL
8 L: 500 mL
Fit or replace the float valve and/or silicone
cap.
Tap the float valve with a long utensil. If
the float valve does not drop, turn the
multicooker off. Contact Customer Care.
Perform the Initial test run to check operation
and record your findings.
Contact Customer Care.
Perform the Initial test run to check operation
and record your findings.
Contact Customer Care.
Turn the steam release handle to the
Sealing position.
This is normal; no action required.
3/3/21 3:33 PM 3/3/21 3:33 PM