Nano Hand Piece; Mounting The Nano Hand Piece And Adjusting The Palm Plate - Albrecht Individual Cds Joint For Dynamic Redression Gebrauchsanweisung

Individual
Instructions For Use

7. Nano hand piece

7.1. Mounting the Nano hand piece and adjusting
the palm plate
Shorten the joint support (CDS
1
2 Loosen the fixing screw from the hand rest.
3 Position the black mounting washer on the joint support. Make sure that the cutting edge
of the joint support is completely covered.
Place the hand rest on the mounting disc. Rotate the palm plate into the desired position
4
and position the locking pin. Make sure that the locking pin of the fixing disk engages in
the drilling pattern of the retaining support.
Secure the hand rest with the supplied screw.
5
1 1
4 4
76 00800 03032900 – INTERNATIONAL SERVICE HOTLINE
Nano anchor straight elongated hole) to the desired length.
®
2 2
5 5
3 3