Adjust Or Change The Position Of The Redression Range On The Cds® Nano Joints - Albrecht Individual Cds Joint For Dynamic Redression Gebrauchsanweisung

Instructions For Use
2.5.2. Adjust or change the position of
the redression range on the CDS
1 Loosen the central screw with the tool supplied until the anchor can be lifted
completely from the gear teeth.
You can adjust the position of the redression range in 10° increments.
2
3 Place the anchor onto the gear teeth and tighten the central screw again.
Please take care to put the Teflon washer in the correct place.
1 1
Nano joints
®
2 2 3 3
www.albrechtgmbh.com 61