Adjust And Set The Cds® Joints /Cds ® Nano Joints; Irons And Holes Of The Pivot Supports And Anchors - Albrecht Individual Cds Joint For Dynamic Redression Gebrauchsanweisung

Instructions For Use
2.3. Adjust and set the CDS
CDS Nano joints
®

2.3.1. Irons and holes of the pivot supports and anchors

The individual special joints and the various anchors are supplied with straight,
non-curved or recessed supports and can be individually processed and adapted
by you.
The following points must be observed when adjusting :
• When you bend the aluminium supports, be sure to heat the aluminium
slightly for the bending operation.
• Always use a round bending iron.
• Bend in several small steps (max. 20° steps).
• Do not bend in close proximity to the joint to avoid damage to the joint
(minimum distance: 5 mm)
• Very small bending radii must be avoided to prevent breakage of the support.
• Multiple corrections and changes to the bend direction must be avoided.
• A maximum bend angle of 90° must not be exceeded.
• When drilling the supports, you should follow the detailed instructions,
especially with VA material. You should always use a HSS/E drill bit to machine
the material and drill at a speed of 400-500 revolutions per minute to prevent
the material from hardening. Suitable HSS/E drills can also be purchased from
albrecht GmbH.
Joints /
®
www.albrechtgmbh.com 55