Control - Menus; Home Screens - Nibe Rmu S40 Installateurhandbuch

Quick access
From the home screens, you reach a new window allowing
quick access, by dragging down a drop-down menu.
Heating
Zone 1
HEAT
Climate system 1
Texten "Snabbåtkomst" ska
Press the icons for quick access to the various function
bytas ut mot p10005 efter att
HMI Light blivit översatt i
pages.
januari.
Quick access
MENU TREE
In the menu tree, you can find all menus and can make more
advanced settings.
Heating
Zone 1
HEAT
Climate system 1
26
Control – Menus

HOME SCREENS

Drop-down menu
HEATING AND COOLING
You make temperature settings for your installation here.
If the climate system in the house has several zones for
heating or cooling, this is shown on the display by a function
page for each zone.
Setting the temperature (without controlling
room sensor activated):
Setting range: -10 – 10
The display shows the set value for heating/cooling (curve
offset). To increase or reduce the indoor temperature, in-
crease or reduce the value in the display.
The number of steps the value has to be changed in order
to achieve a one degree change to the indoor temperature
depends on the climate system. One step is usually enough,
but in some cases several steps may be required.
If multiple zones in a climate system do not have activated
room sensors, these will have the same curve offset.
Setting the desired value. The new value is shown on the
right-hand side of the symbol on home screen cooling.
Setting the temperature (with controlling
room sensor activated):
Heating
Menu tree
Setting range: 5 – 35°C
Cooling
Setting range: 5 – 35°C
The value in the display appears as a temperature in °C, if
the zone is controlled by a room sensor.
NOTE!
The menus and control options that are available
can be controlled by profiles, see section "Create
profiles".
NOTE!
A slow climate system, such as underfloor heating,
may be unsuitable for controlling with room
sensors.
RMU S40 | EN