R&G ECC0285 RHS Montageanleitung Seite 3

Page 3 of 13
FITTING INSTRUCTIONS
• Please ensure the engine is cold before proceeding with the fitment of the R&G
engine case cover.
• Remove the four bolts arrowed in picture 1, hold the cover up to the casing to
identify the correct bolts. DO NOT REMOVE ALL THE ENGINE CASE BOLTS.
• Offer the R&G cover up to the engine case and carefully fit over the casing.
Please ensure that the four bolt holes in the cover are aligned with the holes in
the engine case and then push on as far as it will go.
• Fit the specified bolts through the cover and into the engine case (please see
picture 1).
• Using a 5mm Allen key or socket bit tighten the bolts evenly to pull the cover into
position. DO NOT FULLY TIGHTEN AT THIS STAGE.
• Finally use a torque wrench set at 10 N/m (7lb/ft) to fully tighten.
• It is suggested that you check the tightness of the mounting bolts after the first
heat cycle and then on a regular basis i.e. - when cleaning or once a month.
• NOTE: - For the cleaning of this product you should only use a soft polishing cloth
and a mild general cleaning agent.
• AVOID HARMFUL CHEMICALS. IF IN DOUBT DO NOT USE AS THEY COULD ALTER
THE STRENGTH OF THE COVER.
• R&G will accept no liability if the above procedures and torque setting are not
followed.
PLEASE NOTE
•
removed to allow access to the required bolts please see below.
FITTING INSTRUCTIONS FOR CBR500 R 2019-
Picture 2
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
: - On the CBR500R the right-hand side fairing should be
R&G
www.rg-racing.com
ECC0285
Picture 3
Email: info@rg-racing.com