How To Reset To Factory Default Settings; Maintenance Instructions - Axis A1001 Installationsanleitung

AXIS A1001 Network Door Controller
How To Configure SmartIntego
Note
Make sure that prerequisites listed have been met.
1. Click Browse..., select the csv-file and click Upload file.
2. Select a GatewayNode and click Next.
3. A preview of the new configuration is shown. Disable the door monitors if needed.
Note
The door monitor setting is enabled by default. If the smart handle does not have a door
monitor you need to disable it.
4. Click Configure.
5. An overview of the doors included in the configuration is shown. Click Settings to
configure each door individually.

How to reset to factory default settings

Important
Reset to factory default should be used with caution. A reset to factory default resets all
settings, including the IP address, to the factory default values.
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button while reconnecting power. See .
3. Keep the control button pressed for 25 seconds until the status LED indicator turns
amber for the second time.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90
5. Use the installation and management software tools, assign an IP address, set the
password, and access the product.

Maintenance Instructions

To keep the access control system running smoothly, Axis recommends regular maintenance of the
access control system, including door controllers and connected devices.
Do maintenance at least once a year. The suggested maintenance procedure includes, but is not
limited to, the following steps:
• Make sure all the connections between the door controller and the external devices
are secure.
44