Axis A1001 Installationsanleitung Seite 21

Power source
Power over Ethernet IEEE 802.3af/802.3at Type 1 Class 3
10–30 V DC
The voltage on the Axis product's power outputs is 12 V DC (except for the Auxiliary Connector
which has a voltage of 3.3 V DC). If your connecting device has a maximum ampere rating of for
example 0.3 A, the following conversion gives the power in watts (W):
Power (W) = Voltage (V) x Current (I)
Power = 12 x 0.3 = 3.6 W
The following table shows the available power after connection of the 0.3 A device in the example.
Power source
Power over Ethernet IEEE 802.3af/802.3at Type 1 Class 3
10–30 V DC
The DC output on the following connectors are considered as power outputs: '
• Power Lock Connector
• Power & Relay Connector
• Reader I/O Connector
• Auxiliary Connector
NO TICE TICE
NO NO TICE
The power output of the auxiliary connector has a 3.3 V DC voltage rating.
For connector specifications, see Power Connector on page 25 and Network Connector on page 26.
Performance Levels for Access Control
This section contains performance level information required for UL 294 compliance.
Feature
Destructive Attack Test
Line Security
AXIS A1001 Network Door Controller
21
Total maximum load on outputs
7.5 W
14 W
Available power
7.5 – 3.6 = 3.9 W
14 – 3.6 = 10.4 W
Level
I
I
EN