Connect The Hardware - Axis A1001 Installationsanleitung

AXIS A1001 Network Door Controller

Connect the Hardware

To connect the hardware:
1. If required, remove the cover screw, insert a slotted screwdriver into the cover removal
slot and remove the cover.
2. Connect the Axis product to the network and wait until the network connection has
been established and the product has powered up. If the product is not powered through
Power over Ethernet but will use Ethernet and external power instead, also connect the
product to a SELV compliant limited power source (LPS). For more information about the
power connector (DC input), see Specifications on page 20.
How To Create a New Hardware Configuration
1. Go to Setup > Hardware Configuration and click Start new hardware configuration.
2. Enter a name for the Axis product.
3. Select a door option depending on the number of readers, one (1) or two (2), that will be
connected to the Axis product and click Next
4. Click Close or click the link to view the hardware pin chart.
How to create a new hardware configuration for wireless locks
1. Go to Setup > Hardware Configuration and click Start new hardware configuration.
2. Enter a name for the Axis product.
3. Select a manufacturer for a wireless gateway.
4. Depending on what lock manufacturer you got, proceed according to one of the bullets:
• ASSA Aperio: Click the link to view the hardware pin chart or click Close and go to
Setup > Hardware Reconfiguration to complete the configuration, see Add Assa
TM
Aperio Doors and Devices on page 43
• SmartIntego: Click the link to view the hardware pin chart or click Click here to select
wireless gateway and configure doors to complete the configuration, see How To
Configure SmartIntego on page 44.
How To Create a New Hardware Configuration with Elevator Control (AXIS
A9188)
Important
Before creating a HW configuration you need to add a User in AXIS A9188 Network
I/O Relay Module. Go to A9188 web interface > Preferences > Additional device
configuration > Basic setup > Users > Add > User setup.
Note
Max 2 AXIS 9188 Network I/O Relay Modules can be configured with each A1001 Network
Door Controller
42