Axis A1001 Installationsanleitung Seite 34

AXIS A1001 Network Door Controller
3. Strip the cables and wires as required using a crimp tool.
4. Connect the wires between the door controller and the locks, doors and other devices. For
more information about the connectors and their specifications, see page 18 and page 22.
NO NO TICE NO TICE TICE
• Make sure all the wires are connected correctly. Incorrect wiring could cause damage
to the product.
• Make sure to use wires that meet the requirements. For more information, see Wire Area
on page 22 and, for UL compliance, Requirements for Compliance with UL294 6th Edition 7.
Cable connection example
1
6-pin plug connector
2
Network cable
3
Cable tie (4x)
4
Network connector
Note
• For devices that have been configured in the product's hardware configuration pages, use
the hardware pin chart as a guide on how to connect the pins. For more information
about hardware configuration and the hardware pin chart, see Configure the Hardware on
page 41.
34