Axis A1001 Installationsanleitung Seite 43

1. In A1001, go to Setup > Hardware Configuration and click Start new hardware
configuration.
2. Enter a name for the Axis product.
3. Select Elevator control to include an AXIS A9188 Network I/O Relay Module and click
Next
4. Enter a name for the connected reader.
5. Select the types of readers that will be used and click Finish
6. Click Network Peripherals to complete the configuration see or click the link to go to
the hardware pin chart.
TM
Add Assa Aperio
Before adding a wireless door to the system it needs to be paired with the connected Assa Aperio
communication hub, using Aperio PAP (Aperio programming application tool).
To add a wireless door:
1. Go to Setup > Hardware Reconfiguration.
2. Under Wireless Doors and Devices click Add door.
3. In the Door name field: Enter a descriptive name.
4. In the ID field under Lock: Enter the six-character-long address of the device that you
want to add. The device address is printed on the product label.
5. Optionally, under Door position sensor: Choose Built in door position sensor or
External door position sensor.
Note
If using a external door position switch (DPS), make sure that the Aperio lock device has
support for door handle state detection before configuring it.
6. Optionally, in the ID field under Door position sensor: Enter the six-character-long
address of the device that you want to add. The device address is printed on the product
label.
7. Click Add.
Prerequisites SmartIntego
The following prerequisites needs to be met before proceeding with the SmartIntego configuration:
• A csv-file needs to be created. The csv-file contains information about what
GatewayNode and doors that are used in your SmartIntego solution. The file is created in
a standalone software provided by a SimonsVoss partner.
• The Hardware Configuration of SmartIntego has been done, see How to create a new
hardware configuration for wireless locks on page 42.
AXIS A1001 Network Door Controller
Doors and Devices
43
EN