Becker Centronic SunWindControl SWC52 Montage & Betriebsanleitung Seite 48

Assembly and Operating Instructions
FUNCTION
(Only if the operating device has been removed. To be carried out by qualified
staff only!)
EXTERNAL ON/OFF/SWITCH, ALARM SIGNAL ON/OFF
(Processing external signals, processing alarm signals)
1. You have confirmed the RUNNING TIME function. EXTERNAL SWITCH ap-
pears. (EXTERNAL SWITCH/ON/OFF refers to external control signals. The
factory setting is EXTERNAL SWITCH)
2. Use the +/- button to select the desired setting for the control
inputs.
3. Press OK to confirm your selection.
Note
The following dialogue field will only be displayed when DRIVE CON-
TROLLER has been selected.
4. ALARM SIGNAL ON appears. (ALARM SIGNAL ON is the factory setting)
5. Use the +/- button to set ALARM SIGNAL to ON or OFF as desired. Press OK
to confirm.
6. The ALARM SIGNAL ON/OFF function is now set.
7. For further programming options in the FUNCTION menu refer to the next
section.
48