Possible Faults; Technical Data - ATIKA RT 550 Bedienungsanleitung

Possible faults

Before each maintenance and cleaning work
− switch off device
− wait until the cutting thread is stationary.
− pull out main plug
After repair and before re-operation control and reactivate all security installations.
Fault
Trimmer does not operate.
Trimmer operation
interruptions.
Trimmer does not cut.
Cutting thread is not followed up.

Technical data

Type
Model
Motor rating P
1
Mains voltage / Mains frequency
No-load speed n
0
Cutting diameter Ø
Cutting thread diameter Ø
Thread spool
Thread follow-up
Hand arm vibration
according to EN 786
Sound pressure level L
PA
(according to regulation 2000/14/EG
Schallleistungspegel L
WA
(nach 2000/14/EG)
Dimensions- (Height)
Weight
Protection art
Possible cause
no power
extension cable damaged
main plug, motor or switch defect
with Extension cable defective.
Internal fault.
ON/OFF button defective.
Cutting thread to short/broken.
Device overloaded as grass too high.
No more thread on the spool.
Cutting thread entangled.
Removal
Check power supply, power socket and fuse
protection
Check extension cable, exchange defect
cable immediately
Have motor or switch checked by an
approved electrician or replaced by original
spare parts.
Check extension cable, exchange defect
cable immediately
Please contact the after sales service.
Follow up the cutting thread.
Trim the grass in several passes.
Replace the thread spool.
Recoil the cutting thread.
RT 550
RT 550
550 W
230 V~ / 50 Hz
11000 min
–1
max. Ø 320 mm
1,4 mm
2 x 5 m
Automatik
7,0 m/s
2
83 dB (A)
measured sound power level 94,9 dB (A)
guaranteed sound power level l 96 dB (A)
ca. 80 – 108 cm
ca. 3,6 kg
II
20