Installation; Transport; Place Environment; Adjust Plastic Feet - Kuppersberg Rffi 184 Technischer Hinweis

ENGLISH
INSTALL ATION

TRANSPORT

 Do not carry the refrigerator hori-
zontally or reversely.
 Do not carry the refrigerator by
holding the door or handle; the refrig-
erator shall be carried by lifting the bot-
tom.
PL ACE ENVIRONMENT
 The refrigerator must be placed
on a hard, flat ground; if cushioning
is needed, stable, hard, nonflammable
cushion blocks shall be used, rather
than the foam backing of refrigerator.
 The refrigerator shall be kept
away from damp locations where water
is easy to splash; water or dirt shall be
removed with soft cloth timely to pre-
vent rusting which may have an effect
on the electrical characteristics.
TECHNICAL PASSPORT
French door refrigerator
 Place the refrigerator in a well-
ventilated place, reserve a certain space
around and behind the refrigerator, and
do not cover or block the air grille on
the rear cover plate of compressor at
the back of refrigerator; Keep the refrig-
erator away from heat source or direct
sunlight.
ADJUST PL ASTIC FEET
 When the refrigerator stays in
the packing box, plastic feet are in
tightened state. After carrying it out
from the packing box for placement,
please make sure to adjust two front
plastic feet until the height is suitable;
just adjust two plastic feet with a
wrench or directly by hand.
 Plastic feet and rear rollers
must touch the ground to prevent the
refrigerator from movement, vibration
or noise. When moving the refrigerator,
adjust plastic feet counterclockwise
to keep them off the ground, and then
push the refrigerator gently to move it.
41