Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Application Service - Bosch Nyon 1 270 020 907 Originalbetriebsanleitung

English–12
Power Supply of External Devices
via USB Connection
With the USB connection, it is possible to operate and charge
most devices whose power supply is possible via USB (e.g.,
various mobile phones).
Prerequisite for charging is that the on-board computer and a
sufficiently charged battery pack are inserted in the eBike.
Open the protective cap 9 of the USB port on the on-board
computer. Connect the USB connection of the external device
to the USB port 8 on the on-board computer using the USB
charging cable Micro A – Micro B (available from your Bosch
eBike dealer).
Once the consumer has been disconnected, the USB connec-
tion must be sealed again carefully with the protective cap 9.
 USB connections are not a waterproof. When cycling in
the rain, do not connect any external devices and make
sure that the USB port is fully covered by the protective
cap 9.
Attention: Users connected to Nyon can affect the range of
the eBike.
Notes on Riding with the eBike System
Careful Handling of the eBike
Please observe the operating and storage temperatures of the
eBike components. Protect the drive unit, on-board computer
and battery against extreme temperatures (e.g. from intense
sunlight without adequate ventilation). The components (es-
pecially the battery pack) can become damaged through ex-
treme temperatures.
Keep the screen of your Nyon clean. Dirt can cause faulty
brightness detection. The day/night switch-over in the navi-
gation mode can be distorted.
An abrupt change of environmental conditions, can cause the
screen to fog up from inside. After a short time, a temperature
adjustment takes place and the fog disappears.

Maintenance and Service

Maintenance and Cleaning

Do not immerse any components, including the drive unit, in
water or clean them with pressurised water.
Clean your on-board computer using a soft cloth dampened
only with water. Do not use any detergents.
Have your eBike system checked by an expert at least once a
year (including mechanical parts, up-to-dateness of system
software).
1 270 020 XBN | (12.5.16)
The bicycle manufacturer or dealer may also base the service
date on the distance travelled and/or a period of time. In this
case, the on-board computer displays a message telling you
when the service date is due for four seconds after each time
it is switched on.
For service or repairs on the eBike, please refer to an author-
ised bicycle dealer.
 Have all repairs performed only by an authorised bike
dealer.

After-sales Service and Application Service

In case of questions concerning the eBike system and its com-
ponents, please refer to an authorised Bosch eBike dealer.
For contact data of authorised Bosch eBike dealers, please
refer to www.bosch-ebike.com
Transport
 If you transport your eBike attached to the outside of
your car, e.g. on a bike rack, remove the on-board com-
puter and the PowerPack to avoid damaging them.
Disposal
The drive unit, on-board computer including operat-
ing unit, battery pack, speed sensor, accessories and
packaging should be disposed of in an environmental-
ly correct manner.
Do not dispose of eBikes and their components into house-
hold waste!
Only for EC countries:
According to the European Guideline
2012/19/EU, electrical devices/tools that are
no longer usable, and according to the European
Guideline 2006/66/EC, defective or used bat-
tery packs/batteries, must be collected sepa-
rately and disposed of in an environmentally cor-
rect manner.
The integrated battery pack in the on-board computer may
only be removed for disposal. Opening the housing shell can
destroy the on-board computer.
Please return battery packs and on-board computers that are
no longer usable to an authorised bicycle dealer.
Li-ion:
Please observe the instructions in sec-
tion "Transport", page English–12.
Subject to change without notice.
Bosch eBike Systems