Creality CR-Scan Raptor Benutzerhandbuch Seite 7

Button Instructions
Button
(Play
Button)
(Brightness
Increase)
(Brightness
Decrease)
(Zoom In)
(Zoom
Out)
LED Indicator Instructions
LED Indicator Color
Green (Always On)
Red (Flashing)
Yellow (Flashing)
Orange–Red
(Always On)
Orange (Always
On)
Light Blue (Always
On)
Dark Blue (Always
On)
Scanner Feedback
Press once to start scanning; press again to pause
scanning; press and hold for at least 3 seconds to
end scanning.
Short press once to increase the
brightness/exposure time of the 3D scanning
camera by one level.
Short press once to decrease the
brightness/exposure time of the 3D scanning
camera by one level.
Short press once to zoom in the 3D model by one
level.
Short press once to zoom out the 3D model by
one level.
Status or Meaning
The device is operating normally or the scanning
distance is moderate.
The device is in an abnormal status.
The device is in an upgrading status.
The scanning distance is too close.
The scanning distance is close.
The scanning distance is far.
The scanning distance is too far.
7
LED Indicator
Feedback
The middle LED
indicator flashes
once
/
/
/
/
Reference
Color