VEVOR 9282 Bedienungsanleitung Seite 7

POWER INSTALLATION
The dartboard is designed to be powered by an AC to 5V DC, 500 milliamp (minimum) adapter. For
the DC adapter, it is configured with the DC plug polarity as positive (+) outside, and negative (-)
center. To connect by adapter, plug the DC plug insert into the DC power jack and the AC plug into
an electrical outlet.
1. During use: ensure the connecting cable does not present a tripping or other hazard.
2. After using the dartboard: switch off the power at the mains and unplug the adapter from the
mains and dartboard.
3. Never leave the adapter connected to the dartboard when not in use.
4. Stow the adapter safely when not in use.
IMPORTANT NOTE
1. During shipping or in the course of normal play it is possible for scoring segments of this board to
become temporarily jammed, resulting in a frozen segment. If this occurs, the location of stuck
segment will be detected and displayed. Take the following steps when this error appears:
A. Find the stuck segment which the location is automatically displayed.
B. Press firmly down on the stuck segment until it breaks free and loose. Once stuck segments are
loosened, the error should be gone, and the board should continue to operate normally.
C.
2. This game is designed for use with soft tip darts only. Do not attempt to use steel tip darts or
longer soft tip darts at any time (maximum length: 2.5 cm).
3. Electronic and mechanical reaction time is required between shots. If two shots occur too close
together, pull out second dart and re-throw to properly record your score.
4. Under the environment with electrical fast transient the dart game may malfunction and require
use to reset the dart game.
5. This is an adult game which includes functional sharp points. Children should only play under
adult supervision.
6. Please peel off the protective film at the display area before use.