Electric Safety - Vevor 9282 Bedienungsanleitung

CORRECT DISPOSAL for Display
This product is subject to the provision of european Directive 2012/19/EU. The symbol showing
a wheelie bin crossed through indicates that the product requires separate refuse collection in
the European Union. This applies to the product and all accessories marked with this symbol.
Products marked as such may not be discarded with normal domestic waste, but must be taken
to acollection point for recycling electrical and electronic devices.
This product is of protection class III
Compliance is a EC security certification
FCC Information for Display
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment! This device complies with
Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This product
may cause harmful interference. 2) This product must accept any interference received,
including interference that may cause undesired operation. WARNING: Changes or
modifications to this product not expressly approved by the party.responsible for compliance
could void the user's authority to operate the product. Note: This product has been tested and
found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC
Rules, These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This product generates, uses and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this product does cause harmful interference to radio or
television 2 reception,which can be determined by turning the product off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures. · Reorient or relocate the receiving antenna. · Increase the distance between the
product and receiver. · Connect the product to an outlet on a circuit different from that to which
the receiver is connected. · Consult the dealer or an experienced radio/TV technician for
assistance
WARNING: Please read this manual carefully before using the product. Failure to do so
may result in serious injury.

ELECTRIC SAFETY!

1. Before using, check that the voltage power corresponds to the one shown on the appliance
nameplate. Ensure that the voltage set on the machine corresponds to the electricity supply in your
country.
2. Do not operate any appliance with a damaged cord or plug or after it malfunctions or has been
damaged in any manner. Return the appliance to the nearest authorized service facility for