Connection With The Mains; Operation; Stand-Alone Mode - EuroLite LED D-1000 Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the device to the mains, it starts running. The LED display lights up and you can
choose the desired mode via the buttons MODE, UP, DOWN and ENTER.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.
- STAND ALONE-MODE
• Auto Mode
• Sound Control Mode
• Master/Slave Setting
- DMX-MODE
Menu level 1 Menu level 2
DMX d001~d512
AUTO
SOUND
L-Mode
International
L
N
Function
Setting DMX address
A1 Program 1
A2 Program 2 (no strobe)
A3 Program 3 (strobe)
A4 Program 4 (red LED)
A5 Program 5 (green LED)
A6 Program 6 (Blue LED)
A7 Program 7 (white LED)
A8 Program 8 (amber LED)
A9 Program 9 (pink LED)
S1 Program 1
S2 Program 2 (no strobe)
S3 Program 3 (strobe)
L--1 LEDs on when in sound control mode and no music
L--0 LEDs off when in sound control mode and no music
001~512
Speed
Speed
Speed
Speed
Speed
Speed
Speed
Speed
Speed
Speed
Speed
Speed
20/23
Value
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
1~9
(increasing)
00086340, Version 1.0