Using The External Control Unit; Commissioning The Lifting Column - Phoenix Mecano Rk Rose+Krieger Rkpowerlift Montageanleitung

Working life

7.8 Using the external control unit

Either a RKMultiControl mono- or a RKMultiControl duo-controller can be connected to the lifting
column. The hand switch is not connected with the lifting column but with the controller.
To use the controller and the hand switch, read the corresponding installation instructions for the
RKMultiControl mono or the RKMultiControl duo.
Only use the controllers listed in these instructions.
Otherwise, you may damage the lifting column or the controllers.

7.9 Commissioning the lifting column

Only authorised personnel may commission a drive unit. The safety regulations and instructions in this
installation manual must be read and obeyed.
Before commissioning, you must check the lifting column for damage and note the instructions for
operating same (see section Divergent environmental factors must be approved by RK Rose+Krieger
GmbH.). If you cannot detect any damage, then the lifting column can be used.
46