Priming Procedure - Avdel TX2000 Betriebsanleitung

P r i m i n g P ro c e d u re
Priming may be necessary after considerable use.
Oil Details
The recommended oil for priming is Hyspin
number 07992-00077). Please refer to page 17 for safety data.
Procedure
To enable you to follow the priming procedure below, you will need to obtain a priming kit:
IMPORTANT: REMOVE NOSE ASSEMBLY
All operations should be carried out on a clean bench, with clean hands in a clean area.
Ensure that the oil is perfectly clean and free from air bubbles.
Care MUST be taken at all times, to ensure that no foreign matter enters the tool, or serious damage may result.
• Remove the nose casing from the tool following the instructions on page 12, in reverse order.
• Remove screws and seals from cylinder bleed point, position 1, and reservoir inlet point, position 2, as illustrated
on page 15.
• Invert the tool over a suitable container and actuate the trigger with the battery connected. Waste oil will be ejected
through the bleed screw hole in the cylinder, position 1.
• Replace screw and seal in the cylinder, position 1 only.
• Hold the tool nose up in a vice using soft jaws to avoid damage. DO NOT USE UNDUE FORCE WHEN CLAMPING THE
VICE ON THE TOOL.
• Completely fill the priming pump 07900-00754 with oil.
• Screw the priming pump 07900-00754 into the reservoir inlet point, position 2 with the seal in place.
• Gently pump the bellows on the priming pump repeatedly, inserting oil into the tool and allowing air to be collected in
the priming pump. Continue this process until no further air bubbles are removed from the tool. The reservoir should
now be full of oil. (Please refer to the diagram on page 15, position 2.)
• With the battery connected, actuate the trigger and gently compress the priming pump until the piston begins to
move. Oil will then be drawn into the tool.
• Release the trigger and priming pump allowing the pump bellows to expand and suck air from the tool. Air bubbles
will be visibly expelled from the reservoir inlet point, position 2, into the priming pump.
• Actuate the trigger and cycle the tool until the piston reaches full stroke. Release the trigger allowing the piston to
return and air bubbles to be expelled into the priming pump. Repeat this procedure until no further air bubbles are
expelled into the priming pump. Allow several seconds between each cycle so that the air bubbles have time to
collect in the priming pump.
• Remove the priming pump from the reservoir inlet point, position 2, taking care not to spill excess oil over the tool.
• Top up the reservoir, position 2, to ensure that the tool is completely filled with oil.
• Replace screw and seal in the reservoir, inlet point, position 2.
• Replace the nose casing.
14
®
AWS 15 available in 0.5 litre (part number 07992-00076) or one gallon containers (part
PRIMING KIT : 07900-00789
PART Nº DESCRIPTION
07900-00754 PRIMING PUMP
07992-00076 OIL - 0.5 LITRE HYSPIN AWS 15
07900-00351 3mm ALLEN KEY