Before Starting; Charging Procedure - Avdel TX2000 Betriebsanleitung

B e f o re S t a r t i n g
Before starting, please read and follow the operating instructions carefully.
C h a rg i n g P ro c e d u r e A P - H B W / t u 1 2 0 3
•
The charger must only be used with Avdel
•
Take the charger out of the case and connect to the mains power supply. The solid red LED indicates that the charger is
operational.
•
Insert the battery correctly into the charger with minimal force.
•
If the green LED flashes when the battery is inserted this indicates that the battery is too hot. Remove the battery and allow to cool
before trying again.
•
The battery charging process is indicated by a solid green LED.
•
Re-charging takes up to 40 minutes, depending upon the level of charge remaining within the battery.
•
The end of the charging process is indicated by the flashing green LED.
C h a rg i n g P ro c e d u r e A P / U L E - 1 2 0 1 & A P / U L U J - 1 2 0 1
•
The charger must only be used with Avdel
•
Take the charger out of the storage case and connect to the mains power supply. The Left LED will be SOLID RED. The Right LED
will be SOLID GREEN for 2 seconds - in this time a self-test will be performed - indicating that the charger is operational.
•
If the LH LED FLASHES RED this indicates that the charger is not functioning correctly - charging is not possible. If this occurs
please contact an authorised Avdel representative.
•
Insert the battery correctly into the charger with minimal force.
•
The battery charging process is indicated by the SOLID GREEN RH LED.
•
If the RH LED FLASHES RED when the battery is inserted this indicates that the battery is too hot. Remove the battery from the
charger and allow it to cool before trying again. This will occur when the battery temperature is above 65°C and can result if the
battery is inserted directly after charging or discharging.
•
If the RH LED shows SOLID RED this indicates that the battery is faulty. Remove battery from the charger and do not use.
•
A SOLID YELLOW RH LED indicates that the battery is at least 90% charged. Removing the battery at this point will increase the
service life of the battery. No significant reduction in the performance of the battery will result.
•
A FLASHING GREEN RH LED indicates that the charging process is complete. The battery will now be at 100% capacity. At this
point the battery will be trickle charged until removed. Overcharging of the battery will not occur.
•
When charging a Ni-MH battery the RH LED can be seen to FLASH RED & GREEN. This also indicates that the charging process is
complete.
8
®
batteries.
®
batteries.