Safety Rules - Avdel TX2000 Betriebsanleitung

S a f e t y R u l e s
This instruction manual must be read with particular attention to the following safety rules, by any person
installing, operating, or servicing this tool.
1 Do not use outside the design intent.
2 Do not use equipment with this tool other than that recommended and supplied by Avdel UK Limited.
3 Any modification undertaken by the customer to the tool, nose assemblies, accessories or any equipment supplied by Avdel UK
Limited or their representatives, shall be the customer's entire responsibility. Avdel UK Limited will be pleased to advise upon any
proposed modification.
4 The tool must be maintained in a safe working condition at all times. The operator must follow the Daily and Weekly service checks
as detailed on page 13.
5 The tool shall at all times be operated in accordance with relevant Health and Safety legislation. In the U.K. the "Health and Safety
at Work etc. Act 1974" applies. Any question regarding the correct operation of the tool and operator safety should be directed to
Avdel UK Limited or an authorised representative.
6 The precautions to be observed when using this tool must be explained by the customer to all operators.
7 Do not operate a tool that is directed towards any person(s) or the operator.
8 Always adopt a firm footing or a stable position before operating the tool.
9 Ensure that vent holes do not become blocked or covered.
10 Do not operate the tool if it is not fitted with a complete nose assembly.
11 The stem collector must be emptied when half full.
12 When using the tool, the wearing of safety glasses is required both by the operator and others in the vicinity to protect against
fastener ejection, should a fastener be placed 'in air'. We recommend wearing gloves if there are sharp edges or corners on the
application.
13 Care shall be taken to ensure that spent stems are not allowed to create a hazard.
14 Take care to avoid entanglement of loose clothes, ties, long hair, cleaning rags etc. in the moving parts of the tool which should be
kept dry and clean for best possible grip.
15 When carrying the tool from place to place keep hands away from the trigger to avoid inadvertent start up.
16 Excessive contact with hydraulic fluid oil should be avoided. To minimize the possibility of rashes, care should be taken to wash
thoroughly.
17 Do not operate the tool or the charger in an environment allowing exposure to moisture, rain, combustible fluids or gasses.
18 Regularly check the plug, cord and charger and in case of damage have repairs completed by an authorised Avdel representative.
19 Remove the battery when not in use, or before servicing / repairing the tool.
20 Do not discard batteries into water or fire, (danger of explosion). The battery must be disposed of in accordance with
environmental regulations.
21 C.O.S.H.H. data for all hydraulic oils and lubricants is available on request from your tool supplier.
4