Intent Of Use - Avdel TX2000 Betriebsanleitung

I n t e n t o f U s e
The TX2000 is a battery powered hydraulic tool designed for placing Avdel
(1/4") as shown in the table below and detailed on page 7.
IMPORTANT: The tool, battery and charger must be used in accordance with the operating instructions and safety
rules contained within this manual. The placing of other fastener sizes or materials not included in the table on
page 7 could have a detrimental impact on the working life of the tool and could invalidate the warranty.
The tool should only be dismantled by a Avdel authorised distributor or repair centre. Failure to do so could
invalidate the warranty.
S t a n d a r d To o l K i t
The standard tool kit consists of:
•
A battery powered hydraulic tool
•
A nose assembly and three nose tips
•
A battery and charger
•
A priming pump
•
An Instruction Manual
These are housed in a durable storage case.
S t a n d a r d N o s e T i p s
The three nose tips and nose assembly supplied as standard with the tool make up a nose assembly part kit (71210-15100).
These nose tips will place the range of Avdel
Standard Nose Tip
71210-05002
71210-16070
07381-04701
Please refer to the matrix on page 7 for a full list of the fastener materials and sizes the TX2000 will place along with the
nose tip part numbers required to place them.
6
®
®
breakstem fasteners summarised below.
Fastener Size
3.0mm – 3.2mm ( 1 / ")
8
3.2mm ( 1 / ")
8
4.0mm ( 5 / ")
32
4.0mm ( 5 / ")
32
4.8mm ( 3 / ")
16
breakstem fasteners from 3.0mm to 6.4mm
Fastener Material
Aluminium / Stainless Steel / Copper
Steel / Stainless Steel
Aluminium / Stainless Steel / Copper
Steel / Stainless Steel
Aluminium