Battery Handling - Avdel TX2000 Betriebsanleitung

B e f o re S t a r t i n g
A summary of the charger LED signals are shown in the table below:
1. LEFT LED
Solid Red LED:
Flashing Red LED:
To achieve the optimum performance from the battery, please adhere to the following guidelines when charging:
•
Aim to charge when both the battery and charger are cool. Optimum charge capacity is achieved when charging a battery
at 28°C.
•
A new battery will only reach full capacity after several charges.
•
To increase the service life of the battery, remove from the charger when the RH LED shows solid yellow.
•
To increase the service life of the battery, only re-charge when no further fasteners can be placed.
•
To achieve the maximum number of cycles from a battery use directly after charging.
B a t t e r y H a n d l i n g & D i s p o s a l
•
Batteries must only be charged using the Avdel
•
Only re-charge batteries when cool. Optimum charge capacity is achieved at 28°C.
•
The battery can be charged up to 1000 times. Optimum life is achieved when used at 22°C. The battery will reach its full capacity
only after several charges.
•
The surrounding temperature must not exceed 50°C (122°F) or be below -40°C (-40°F) for the battery to operate.
•
For optimum life and performance only re-charge the battery when no further fasteners can be placed.
•
For optimum performance use the battery directly after re-charging.
•
Significantly reduced operating time of the battery after a complete re-charge indicates that the battery needs replacing.
•
Store the battery in a frost free and dry environment.
•
To ensure that the batteries are disposed of correctly please return to an authorized recycling centre.
•
Used batteries must not get into waste, fire or water under any circumstance.
Charger Operational
Charger Faulty - Do not use
®
charger supplied.
2. RIGHT LED
Solid Green LED: Charging In Progress
Solid Yellow LED: Battery At Least 90% Charged
Flashing Green LED: Charging Process Complete -
100% Charged
Flashing Red & Green Charging Process Complete -
LED: Ni-MH
Solid Red LED: Battery Faulty Or Damaged -
Do Not Use
Flashing Red LED: Battery Too Hot Or Cold
9