Changing Nose Equipment - Avdel TX2000 Betriebsanleitung

C h a n g i n g N o s e E q u i p m e n t
IMPORTANT: The battery must be disconnected when fitting or removing the nose assemblies.
Item numbers in bold refer to nose assembly components illustrated below.
•
Remove items in reverse order to that shown below
•
Lightly coat jaws 4 with Moly-lithium grease.
•
Drop jaws 4 into jaw housing 3.
•
Insert jaw spreader 5 into the jaw housing 3.
•
Locate buffer 6 on the jaw spreader 5.
•
Locate spring 7 onto jaw spreader 5.
•
Fit locking ring 8 onto the jaw spreader housing of the tool.
•
Holding the tool pointing down, screw the assembled jaw housing onto the jaw spreader housing and tighten with spanner.
•
Screw the nose tip into nose casing 1 and tighten with nose tip spanner. Nose tip spanner 71600-02024 included with the
tool will fit the three nose tips supplied with the tool as standard.
•
Place nose casing 1 over jaw housing 3 and screw onto the tool, tighten with spanner.
8
12
N O S E A S S E M B L Y
part nº 71210-15000
(+ 3 nose tips above = 71210-15100)
ITEM DESCRIPTION
1 NOSE CASING
2 'O' RING
3 JAW HOUSING
4
5 JAW SPREADER
6
7
8 LOCKING RING
7 6 5 4
PART Nº
07340-00306
07003-00067
07340-00304
JAWS 71210-15001
07498-04502
BUFFER 71210-05001
SPRING 07498-04301
07340-00327
3 2 1
22.9
61