Remarks For Use In Potentially Explosive Atmospheres (Atex) - Dresser Rr 16 Bedienungsanleitung

Remarks for use in potentially explosive atmospheres (ATEX):

• If film of rust is possible (flying rust in the immediate product surroundings), all outer aluminium parts have
to be protected accordingly (e . g . by varnish) .
• The product must be electrically connected to adequately earthed installation .
• For installation, removing or repair of the product on site, only tools allowed for the corresponding explo-
sion area can be used .
• The product shall not be exposed to: flames, ionised radiation and ultrasound .
Ex-protection
• The device does not have any potential ignition sources and thus ATEX 95 (94/9/EG) does not apply to it
(applied electronic accessories comply with the ATEX requirements) .
Manufacturer:
Applied conformity assessment
procedures PED:
Applied harmonized standards:
Other applied EC-Directives:
Engaged notified body:
Module D, Surveillance of the QS-System: TÜV SÜD Industrie Service GmbH, Westendstraße 199, D-80686 München
Module B, EC type examination certificate: DVGW CERT GmbH, Josef-Wirmer Straße 1-3, D-53123 Bonn
Examination/inspections/tests
during manufacturing:
Surveillance of the QS-System:
EC type examination certificate No:
Regulators according to EN 334 - if not equipped, with any electronic device – do not have a potential ignition source and
therefore are not in the scope of European directive 2014/34/EU.
D2036027_AC_EU_Declaration_RR16.docx
EU Declaration of Conformity
gas pressure regulators for natural gas and all non-corrosive gases
with or without safety shut-off valves for OPSO and UPSO
Itron GmbH, Hardeckstraße 2, D-76185 Karlsruhe
declares under his sole responsibility, that the regulator
RR16...
is in conformity with the Gas Appliance Regulation EU/2016/426
and the Pressure Equipment Directive EU/2016/426
The regulator with our without safety shut-off valve has been classified as safety
accessory in category IV, by the manufacturer. The used fluids are classified in
group 1 according article 13.
Module B + D
DIN EN 334:2005+A1:2009 and DIN EN 14382:2005+A1:2009+AC:2009
2014/30/EU, electromagnetic tolerance
- EN 61000-6-2 (2016); EN61000-6-3 (2006 + A1:2010), EN 60947-5-2 (2014)
2011/65/EU, RoHS
- EN 50581 (2012)
only for optional electronic device
TÜV SÜD Industrie Service GmbH, Westendstraße 199, D-80686 München
DGR-0036-QS-955-17
CE-0085 AQ1103
Karlsruhe, April 21
K. Zinnitsch
Managing director
, 2018
th
23