Renkforce 1592620 Kurzanleitung Seite 3

Quick guide
RF100 XL 3D printer fully-assembled
Item no. 1592461 RF100 XL Plus
Item no. 1592620 RF100 XL
Delivery content
• 3D printer fully-assembled
• 250 g original Renkforce PLA filament
(1.75 mm white)
• 8 GB SD card with "Cura" software,
100+ ready-to-print 3D model files
• Power adapter
• Mains cable
• Quick installation guide (in German and
English)
• Filament spool holder
• Filament tube
• USB cable
• Scraper
• Tweezers
Detailed Operating Manuals
A detailed operating manual
www.conrad.com/downloads or you can scan the QR code on this page.
Follow the instructions on the website.
Product picture
Features
• Max. size of the printed object
200 x 200 x 200 mm
• Print various materials
such as PLA, wood, elastic, copper;
- additional ABS (with item no. 1592461)
• Printed layer thickness 0.1 mm - 0.2 mm
• Print speed 30 mm/s - 300 mm/s
• Colour touch screen display
• Side cutters
• 2.0 mm hex key
• 2.5 mm hex key
• 2x screw
• Glass print bed with pre-installed print bed
film (with item no. 1592620)
- includes heating plate and accompanying
blue tape (with item no. 1592461)
• 5 x original Renkforce filament samples
(copper, wood, glow-in-the-dark, colour-
change and elastic
- each one 1.75 mm - 50 g)
• 50 g ABS filament (1.75 mm black)
(with item no. 1592461)
can be downloaded from
• Nozzle size 0.4 mm
• Supports printing from SD card, PC and
USB
• "Cura" software included
• Single extruder
Setting up the equipment
1
• Install the print bed.
3
Only with item no. 1592461
• Insert the heating plate cable into the
cable holder (on the lower side of the
print bed).
5
• Insert the SD card with the label side
facing downwards.
7
• First connect the mains cable to the
power adaptor, then connect the power
adaptor power cable to the 3D printer.
• Plug the mains plug on the power
cable into the mains socket.
• Switch the 3D printer on.
Print bed calibration
1
• Tighten the 3 levelling screws under
the print bed as far as they will go.
2
Only with item no. 1592461
• Lift up the protective cover on the
heating plate power connection ( 1
• Plug the heating plate power cable into
the power connection ( ).
2
• Secure the connection: turn the lock nut
in the heating plate connecting plug.
4
• Using two screws and the 2.5 mm hex
key, attach the filament spool holder at
the back of the 3D printer.
The "nose" on the end of the bracket
points upward.
6
• Cut through the cable tie on both sides
using the side cutters.
8
• < ReadyPrint > appears on the touch
screen display. The 3D printer is now
ready for use.
2
• Place an A4 sheet of paper between
the nozzle and the print bed to use as
a measurement guide.
).