Renkforce 1592620 Kurzanleitung Seite 4

3
• In the < ReadyPrint > menu, first select
< Set > then < Levelling >.
• Press < First > (first point). Nozzle
moves to the first point.
• The distance between the nozzle and
print bed is controlled by turning the
first levelling screw.
• The paper should be lightly clamped,
so that you feel slight resistance when
moving the paper.
Installing the filament
1
• Mount the filament on the spool holder.
3
• Insert the filament into the tube until
approximately 5 cm is visible at the
extruder end.
Filament feed
1
• In the < ReadyPrint > menu, select
< Move > and then press < Z+ > twice
to increase the distance between the
nozzle and the print bed.
3
• In the < Filament > menu, wait until the
actual temperature (in this case 221 °C)
has reached the target temperature.
• Press < Load >.
4
• Repeat STEP 3 for the second, third,
and fourth point (calibration sequence
and motion direction of the nozzle are
shown).
2
• Insert the filament tube into the tube
holder.
2
• In the < ReadyPrint > menu, first select
< Filament >, then < Preheat >.
• Press < Add > several times until
the target temperature of 220 °C is
reached.
4
• The LCD panel displays the status
notification < filament changing >. The
3D printer is now ready for the filament
feed-in.
5
• Slide the filament forward gently until
the filament is slowly fed into the
extruder.
• Release the filament.
Starting the printing process
1
• In the < ReadyPrint > menu, first select
< Print > then < PageDown >, several
times if necessary, until the folder
< 3D Models > is shown.
• Open the < 3D Models > folder.
3
• Confirm printing with < OK >.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights reserved, including translation. Reproduction by any method, i.e. photocopy, microfilm, or in digital, electronic,
optical or in any form, requires prior written approval from the publisher. Reproduction by printing, even in part, is also
prohibited. This publication represents the technical status at the time of printing.
Copyright 2017 by Conrad Electronic SE.
6
• If filament comes out of the nozzle,
press < Stop >.
• Remove the filament remnants with a
pair of tweezers.
2
• In the < 3D models > folder, select a
ready-to-print model,
e.g. < RF100.gcode >.
4
• DONE.
*1592461_1592620_V1_1017_02_LS_qsg_EN