Velp Scientifica ECODryBlock Bedienungsanleitung Seite 12

•
"RESET" Button: to restore all system settings (listed in the table above) to their default values. To perform a reset,
press and hold the button for three seconds, until it turns blue;
•
"SETUP" Button: to open the Setup page (see
To exit the "User Menu Page", press the "X" button.
Methods Page
The instrument features a list of standard and custom methods. Each method consists of one to eight programmable ramps,
each with individually adjustable temperature and time values.
From the Method Page, it is possible to access the Standard Methods Page or the Custom Methods Page.
Custom/Standard Methods Page
This page allows the user to select a method or access the Method settings page. On the Method settings Page, users
can view or modify the method name, the number of ramps and temperature and time of each ramp.
Method details can be modified only for custom methods. Standard methods are view-only.
To select and import a method, touch the desired method and press the "X" button. To access the Method Details Page,
touch the method and then press the "DETAILS" button.
Method settings Page
•
F2 – Method Name Window: displays the method name.
Only for custom methods, it is possible to modify the method name:
- Select the window by touching it. The first letter is highlighted;
- Use the "+" (P4) and "−" (P5) buttons to select the letter;
- Touch again the window to switch to the following letter;
- Repeat the previous two point for all the letters of the name.
•
F3 – Number of Ramps Window: displays the number of ramps of the selected method.
Only for custom methods, it is possible to modify the number of ramps:
- Select the window by touching it;
- Use the "+" (P4) and "− " (P5) buttons to select the number of ramps.
•
F1 – Ramp Details Window: displays the temperature and timer values associated to each ramp.
Only for custom methods, it is possible to modify the temperature and timer of the ramps:
- Select the temperature / hours (hh) or minutes (mm) window by touching it;
- Use the "+" (P4) and "− " (P5) buttons to select the temperature/timer value.
•
P1 – Exit Button: to exit the page and go back to the Custom/Standard Methods Page, without saving the changes
applied to the method
•
P2 – Save Button: to exit the page and go back to the Custom/Standard Methods Page, saving the changes
applied to the method
•
P3 – Confirm Button: to exit the page and go back to the Home Page, saving the changes applied to the method
and importing the method for an analysis
Chapter 3. Operation).
12