Maintenance & Repair; Replacing The Solenoid Valves / Replacing The Filter - Cgs Instruments Sam-1000_Dp Bedienungsanleitung

9 Maintenance & repair
Maintenance or repair must only be performed by CGS service technicians. This can also be done by
CGS-instructed / trained technicians.
The warranty and liability expires in case of unauthorised maintenance or repair work.
The applicable safety and accident prevention regulations must be observed in any case.

9.1 Replacing the solenoid valves / replacing the filter

• To replace the solenoid valve, unscrew it using a hook spanner (Item No.: 1017105)
• O-ring (Item No.: 1026311) and the filter (Item No.: 1026309 (50µ)) are located on the bottom of the
connection
• To change the filter frits, loosen the Allen screws and remove the connection
• Remove the O-ring and take out the filter
• Before inserting the new filter and O-ring, clean the contact surfaces of the O-ring so that it can
properly seal.
Product:
SAM-1000_DP Revision 1.2 – Issue July 2016
E
75/88