Delivery Information; Norms And Regulations - Cgs Instruments Sam-1000_Dp Bedienungsanleitung

Proper maintenance means:
• Adherence to the maintenance plan (see Chapter: Maintenance)
• Maintenance by trained maintenance personnel
• Use of original CGS spare parts
Maintenance should be performed by the CGS service technician or, on the operator side, by CGS-trained
service technicians.
The warranty is void in case of:
• improper use
• use of unauthorised equipment
• faulty connection and existing components that are not part of the scope of delivery and service
• failure to use original spare parts and accessories
• retrofitting that was not performed by CGS itself
• non-compliance of prescribed maintenance work
The contents reflect the state of the art at the time of publication.
We reserve the right to make any technical changes due to further development.

1.8 Delivery information

The respective scope of delivery is listed in the shipping documents accompanying the delivery based
on the valid contract.
Please observe the corresponding information on the packaging material when opening the packaging.
Check the delivery for completeness and intactness. In particular, you should, where applicable, compare
the order number on the nameplates with the ordering data.
If possible, please keep the packaging materials so that you can use it for future return deliveries
(see Chapter: Packaging and transport).

1.9 Norms and regulations

The specification and production of this device were based on the harmonised European Norms whenever
possible. If no harmonized European Norms have been applied, then the norms and regulations of the
Federal Republic of Germany shall apply.
When using this product outside the scope of these norms and regulations, you must comply with the
norms and regulations valid in the operator's country.
Product:
SAM-1000_DP Revision 1.2 – Issue July 2016
E
51/88