CGS Instruments SAM-1000_DP Bedienungsanleitung Seite 66

E
Figure 6-3 Parameter screen 2/4
The sample gas pressure monitoring of SAM-1000_DP takes place by an analog measurement. The
parameter settings of this measurement are done on parameter screen 2.
„min. pressure" on falling below this value I0.0 „sample gas pressure low" is set "0" (fault state)
„20 mA" upper limit for scaling the analog value of pressure transmitter
The actual pressure is shown in the lower field.
The Profibus address of SAM-1000_DP is set in the field "DP slave/address". With touching the button
"Apply" the actual address of SAM-1000_DP is overwritten. The address should be set before the
SAM-1000_DP is connected with Profibus. Otherwise there can be address conflicts, if this address exists
on Profibus already.
Product:
SAM-1000_DP Revision 1.2 – Issue July 2016
66/88