Sleep Mode - Enforcer Bionic Foot Gebrauchsanweisung

2.4.6 Sleep mode

The mode allows the prosthesis to be completely switched off. Activating this mode enables the
maximum extension of battery life.
Activation the mode is possible only through the mobile application in the modes section, according to
point 3.10.
Deactivation the mode is only possible by connecting the charger, before doing so, please refer to the
2.2.1 section of this manual.
2.4.7 Ladder mode
Attention:
In this mode, power consumption increases significantly. Use only when necessary.
This mode allows complete stiffening of the prosthesis regardless of external conditions.
Activation the mode can only be activated via the mobile application in the modes section, in
accordance with the 3.10 point. After activating the mode in the application, stand in a naturally upright
position, as in the first calibration step. Only then will the mode be activated.
Deactivation is possible via the mobile application, as well as by setting the prosthesis in a horizontal
position, e.g. by bending the knee joint at an angle of 90 degrees.
2.5 Product functions overview
2.5.1 Bluetooth
Bluetooth functionality is utilized for communication with the mobile app. To extend the prosthesis's
working time, we recommend disabling the Bluetooth connection when not actively connecting to the
app.
Activation is done by placing the prosthesis in a specific position as shown in the illustration 5 (for
example, by taking off the prosthesis and rotating the foot upward) for 5 seconds. The activation of
Bluetooth is indicated by the steady flashing of half of the LED ring in blue and the other half in green,
as shown in the Table 1.
Deactivation is done similarly. Bluetooth deactivation is signaled by the even pulsating of half of the
LED ring in blue and the other half in red, as shown in the Table 1.
INSTRUCTIONS FOR USE (ENG)
46