Standby Mode - Enforcer Bionic Foot Gebrauchsanweisung

Activation/Deactivation is performed using both the gesture and the application in the Modes panel, as
described in the section 3.10. To change the state (enable or deactivate the mode) using a gesture (see
Figure 4), hold the prosthesis in maximum dorsal flexion for 10 seconds.
2.4.4 Bike mode
To facilitate and ensure predictable performance in bike mode, the prosthesis maintains a constant level
of damping, matching the resistance of the magnetorheological damper.
Activation/Deactivation only through the mobile application in the Modes section described in point
3.10.
Recommendations: it is recommended to use the mode while cycling.

2.4.5 Standby mode

In this mode, damping is inactive, allowing the foot to fall freely when sitting.
Activation when the prosthesis remains immobile for 2 minutes. In this mode, the prosthesis consumes
significantly less energy, thereby extending its service life.
Deactivation occurs when the foot is lightly stomped or impacted on the ground. The prosthesis is ready
for use once the actuation procedure is completed.
Figure 4: Prosthesis position in dorsal flexion.
INSTRUCTIONS FOR USE (ENG)
45