Programme Mode (Customizable Programming) - Mistral 6Ttr Benutzerhandbuch

Mistral 6TTR-10TTR – Pag. 55
4. Setting the oven chamber climate:
After setting the temperature value, the legends "Dry" (blue) and "Steam" (red) flash in
sequence on display 3. Using the "+" key, you can increase the percentage value of steam
injection during the baking cycle. The numerical scale of display 3 will be red Using the "-"
key, you can decrease the percentage value of steam injection during the baking cycle.
The numerical scale of display 3 will be blue. Once the desired climate has been set,
confirm the parameter by pressing the
excludes the Climate parameter from the programming.
 Store all the settings by pressing and holding down the
Now all the parameters for manual baking have been set. Press the
programme. The oven begins its baking cycle with the preheating phase (if set during the
programming phase). The end of this phase will be indicated by an acoustic signal and the flashing
of the lamps inside the chamber. Open the door and place the product in the oven. Once the door
has been closed, the actual baking cycle will begin. You can stop the baking cycle before it's
programmed to end simply by pressing the
The set parameters can be changed at any time during the baking cycle (except during the
preheating phase). Press the
confirm by pressing the

PROGRAMME MODE (CUSTOMIZABLE PROGRAMMING):

 The ovens of the Mistral Series allow you to store up to 60 baking programmes, customized
according to the user's needs. Up to 5 Steps are available, each of which include: time,
Multi-timer (if selected), fan speed, temperature, and climate. At the start of the
programmed baking cycle these steps will be executed in sequence, thus dividing the
programme into true complete cooking phases.
To store a programme, proceed as follows:
 Press the
the operation by pressing the
the
programme. Confirm the setting by pressing the
 Now you can start programming the Steps: the "Step 1" icon comes on to indicate the first
sequence of parameters that will make up the programme. Set each parameter,
confirming the value with the
 To move from one "Step" to another, press the
key, change the desired value using the "+" and "-" keys and
key. The changes will take effect immediately.
key. Using the "+" and "-" keys, select the first empty programme
key and use "+" and "-" to choose whether to include this phase in the
key. Setting the value at 0 (display flashing)
key for 3 seconds.
key. The first option refers to the pre-heating: press
key.
key.
key.
key for 3 seconds.
key to start the
.
Confirm