Ryobi RAG750-115 Übersetzung Der Originalanleitung Seite 4

FURTHER SAFETY INSTRUCTIONS
OPERATIONS
Kickback and related warnings
Pinching or snagging causes rapid stalling of the rotating
accessory, which in turn causes the uncontrolled power
tool to be forced in the direction opposite of the accessory's
rotation at the point of the binding.
pinch point can dig into the surface of the material causing
direction of the wheel's movement at the point of pinching.
operating procedures or conditions and can be avoided by
Maintain a firm grip on the power tool and position
your body and arm to allow you to resist kickback
forces. Always use auxiliary handle, if provided, for
maximum control over kickback or torque reaction
during start-up. The operator can control torque
Never place your hand near the rotating accessory.
Do not position your body in the area where power
tool will move if kickback occurs.
the tool in direction opposite to the wheel's movement at
the point of snagging.
Use special care when working corners, sharp
edges, etc. Avoid bouncing and snagging the
accessory. Corners, sharp edges or bouncing have a
tendency to snag the rotating accessory and cause loss
Do not attach a saw chain woodcarving blade or
toothed saw blade. Such blades create frequent
ADDITIONAL SAFETY
GRINDING AND CUTTING-OFF OPERATIONS
Use only wheel types that are recommended for
your power tool and the specific guard designed for
the selected wheel. Wheels for which the power tool
was not designed cannot be adequately guarded and
are unsafe.
The grinding surface of centre depressed wheels
must be mounted below the plane of the guard lip.
plane of the guard lip cannot be adequately protected.
The guard must be securely attached to the power
tool and positioned for maximum safety, so the least
amount of wheel is exposed towards the operator.
2
Original Instructions
FOR ALL
INSTRUCTIONS FOR
wheel fragments, accidental contact with wheel and
Wheels must be used only for recommended
applications. For example: Do not grind with the
side of cut-off wheel. Abrasive cut-off wheels are
intended for peripheral grinding, side forces applied to
these wheels may cause them to shatter.
Always use undamaged wheel flanges that are of
correct size and shape for your selected wheel.
Proper wheel flanges support the wheel, thus reducing
wheels may be different from grinding wheel flanges.
Do not use worn down wheels from larger power
tools. Wheel intended for larger power tool is not
suitable for the higher speed of a smaller tool and may
burst.
ADDITIONAL SAFETY WARNINGS SPECIFIC FOR
ABRASIVE CUTTING-OFF OPERATIONS
Do not "jam" the cut-off wheel or apply excessive
pressure. Do not attempt to make an excessive
depth of cut. Overstressing the wheel increases the
loading and susceptibility to twisting or binding of the
Do not position your body in line with and behind
the rotating wheel. When the wheel, at the point of
operation, is moving away from your body, the possible
tool directly at you.
When wheel is binding or when interrupting a cut
for any reason, switch off the power tool and hold
the power tool motionless until the wheel comes to
a complete stop. Never attempt to remove the cut-
off wheel from the cut while the wheel is in motion
otherwise kickback may occur.
corrective action to eliminate the cause of wheel binding.
Do not restart the cutting operation in the workpiece.
Let the wheel reach full speed and carefully re-enter
Support panels or any oversized workpiece to
minimize the risk of wheel pinching and kickback.
sides of the wheel.
Use extra caution when making a "pocket cut" into
existing walls or other blind areas. The protruding
wheel may cut gas or water pipes, electrical wiring or
ANGLE GRINDER SAFETY PRECAUTIONS
equal to or greater than the rated speed of the product.
Ensure that the dimensions of the grinding wheel are