cecotec FAST&FURIOUS 5040 ABSOLUTE Bedienungsanleitung Seite 46

ENGLISH
6. The iron is ready for use.
Self-clean function
The self-clean function is a permanent system located inside the water tank to eliminate
impurities in water and reduce the problems derived from limescale build-up. To prolong the
efficiency of this system, follow these steps regularly:
1. Fill the iron with water up to the Max. mark and heat the iron to the maximum temperature.
Wait until the LED light indicates that the temperature has been reached.
2. Unplug the iron and carry it to a sink, hold the iron horizontally over the sink, and press the
self-clean button.
3. Shake the iron so that all limescale and dirt falls into the sink through the holes in the
soleplate. Repeat this procedure several times.
4. Reheat the iron and wipe the soleplate with a cloth to remove any limescale and dirt that
may have remained inside.
5. It is recommended to do this at least once every two weeks. For very hard water, a weekly
cleaning is recommended instead.
Anti-drip function
This system controls the water flow always emitted to the soleplate. Below a certain
temperature, the anti-drip function cuts off the water flow and prevents the iron from dripping
water onto the fabric.
Automatic shut-off function
- The iron will automatically turn off when placed in horizontal position for 30 seconds, or in
an upright position for 8 minutes. To indicate that the iron has been turned off, the unit will
beep 6 times, and the auto shut-off indicator light will blink. The iron can take up to 45-60
minutes to completely cool down.
- To heat up the iron again:
1. Pick up the iron or slightly move it.
2. The auto shut-off light indicator will stop blinking.
3. The auto shut-off light indicator will remain on, and the iron will be ready to use.
ECO mode
Use this mode for optimal results when steam ironing any type of fabric. This position
guarantees good results saving energy.
How to use the water spray
- Before using the spray function, check the fabric label for ironing instructions, as some
fabrics may be spotted or stained with moisture.
- The spray function is particularly helpful to remove stubborn wrinkles and whenever extra
moisture is needed. The spray may be used both with steam or dry ironing. Simply press
the spray mist button when desired.
46
IRONHERO 2600 FORCE