EN
WARNING
•
: To reduce the risk of fire, keep textiles, curtains, or any other flammable
material a minimum distance of 1 m from the air outlet
• The heater should be hung on the wall and make the wind outlet down or be placed on
flat appliance. You must not place it precipitantly or tipsily.
Please do not use the heater in the place where full of combustible or explosive gas.
•
Don't cover the wind outlet.
The electrical socket must be equipped with earth wire, its capacity should be
•
250V~10A or exceed 250V~10A. The socket and the power plug should be in good
connecting condition.
If nobody is in using or you are repairing the heater, please pull off the plug.
•
Please don't touch the heater by the wet hand or other conductor.
•
If motor is not working properly, please stop it immediately.
•
During using the heater, please do not open the door or window continually otherwise it
•
will influence the heating effect.
If want to shut off the heater, press the on/off switch to off, then the heater will keep the
•
fan working 30 seconds until it blowing out cool wind, then the heater will stop working,
and you may pull off the plug.
Please remove the baffle before using the remote control.
•
If don't use remote control, please put the insulation paper back into the remote control
•
to ensure that the battery power is enough.
The heater must be installed at least 2 m above the floor.
•
If the heater needs repair, please ask for special person.
•
SPECIFICATIONS
Model
ZPT-2000B 5009BL
INSTALLING THE DEVICE
The heater shall be installed and used according to the safe
standard.
To avoid all dangers, follow the safety instructions.
•
The installation must be done by the service agent or similarly qualified persons in
•
order to avoid a hazard.
Important! Make sure that there are no electric cables or other installations (for
•
example water pipes) near the drill holes. Make sure that the appliance is securely and
vertically fitted to the wall.
Voltage
220-240V~
2
Frequency
50-60Hz
Power
2000W