Using The Heater; Overheat Protection - HOMCOM 820-318V70 Bedienungsanleitung

USING THE HEATER

1. Before inserting the plug into an electrical outlet, make sure that the electrical
supply in your area matches that on the rating label on the unit.
2. When plugged in, turn on the Main power switch at the base side of unit.
3. When in Standby mode, only
Press ++ to access the rest of the control panel.
a) Low Power: (Press
b) High Power: (Press
c) Timer: Press
itself off (between 0 hour to 8 hours)
d) + , - : adjust room temperature .Temperature setting from 10-49 degree. "+"
to increase the desired temperature and "-" to decrease the desired temperature
Press it to light On/Off the display
e)
f) Press it to turn on/off the flame effect ,it can be used independently.
g) , turn on or turn off item . item always keep working 30 seconds of cool air
after turn off it . this design can protect item use longer.
Warning:
1. Before removing the plug from the socket, switching off and better work for
30-60 second for cool down in condition that protecting inner parts.
Remote control
Please use Lithium battery CR2025 3V.
NOTE: the remote control buttons perform the same functions as those on the
control panel on the unit.
on the control panel will respond to your touch.
to switch it)
to switch it)
repeatedly to set a period after which the heater will turn

OVERHEAT PROTECTION

This heater is protected with an overheat protection that
switches off the appliance automatically in case of
overheat,e.g. due to the total or partial obstruction of the
grids. In this case, unplug the appliance, wait about 30
minutes for it to cool and remove the object which is
obstructing the grids. Then switch it back on as described
above. The appliance should operate normally. Should the
problem persist, please contact the nearest customer
service.
NOTE: To assist in maintaining the internal components,
after pressing the ++ button the fan
will continue to blow room air for a period of 30-60 seconds
before shutting down to standby.
3