HOMCOM ZPT-2000B 5009BL Bedienungsanleitung Seite 5

EN
2. Pressing the "MODE" button on remote control ,the unit will blow the warm air and "
AA " light is on with white color.
Pressing the "MODE" button second times on remote control, the unit will blow the
hot air and "
3. Pressing the "MODE" button three times on remote control, the unit will blow the
cold air and "
4.Pressing the "SWING" button on the remote control ,the unit will Louver swing up
and down. AND the "
function， and the "
PS: For smart operate, customer only press the one start button near about
master button, the heater will working with hot air and both "
AAA "lights are on.
One start Button
2) 24H Timer FUNCTION
1. Open the appliance as working conditions,(fan,warm,hot are all ok).This function
through by Remote control "
2. Press "
increase the hours from 00:00 – 24:00(01:00=1hour,...24:00=24 hours ect.) and the
"D" light is on.
PS: set as "00:00" means no set timer , the "D" light is off.
3) THERMOSTAT INSTRUCTIONS
1. Open the appliance as working conditions,(fan,warm,hot are all ok).This function
only through by Remote control.
2. To adjust temperature, press the "
temperature set from 10℃ to 49℃
3. When the air temperature drops 2 degree below the set temperature, the heater will
start heating with hot air.
4. When the air temperature high 1 degree or ≤ the set temperature, the heater will
blow the cold air .
" light is on with white color.
" light is off.
" light is on. Pressing again will be closed swing
" light is off.
" button ,set the timer up to 24 hours, keep press "
" button.
" to set the desired temperature and the
4
" " " "
" button to