Installing The Unit (In-Dash Mounting); Basic Procedure - Kenwood KMM-BT504DAB Bedienungsanleitung

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate (B) Trim plate
(C) Mounting sleeve (D) Wiring harness
(E) Extraction key

Basic procedure

1 Remove the key from the ignition switch, then disconnect the
[ terminal of the car battery.
2 Install the DAB antenna.
See Installing the DAB antenna. ( 33)
3 Connect the wires properly.
See Wiring connection. ( 32)
4 Install the unit to your car.
See Installing the unit (in-dash mounting).
5 Connect the [ terminal of the car battery.
6 Press
to turn on the power.
7 Detach the faceplate and reset the unit within 5 seconds. ( 3)

Installing the unit (in-dash mounting)

Hook on the top side
Orientate the trim plate as
illustrated before fitting.
How to remove the unit
1 Detach the faceplate.
2 Remove the trim plate.
3 Insert the extraction keys deeply into the
slots on each side, then follow the arrows as
shown on the illustration.
Do the required wiring.
( 32)
Dashboard of
your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
ENGLISH
31