HOMCOM 800-211V70 Bedienungsanleitung Seite 8

EN
Boiling:
Default Mode: Touch "Boil/Cancel" button, there will be one sound and display show the
inside water temperature after three blinks, the kettle start to work under "100°C" setting.
When reaching 100 degree C, heating light distinguish. Heater stops.
Temperature setting: Hand touch the temperature + or - button for selecting the desired
cooking temperature (40/50/60/70/80/90/100 degree C). Then touch the "Boil/Cancel"
button to start the boiling. When reaching 100 degree C, heating light distinguish. Heater
stops.
Keep Warm:
Hand touch the temperature + or - button to set the keep warm temperature
(40/50/60/70/80/90degree C). Then touch the " Keep warm" button. Both heating
indicator light and keep warm indicator light will be on. The display show the inside
water temperature after three blinks. Kettle start to work. When the water temperature
reach the setting temperature, then the kettle will stop work after two sounds and then
come into keep warm mood. The heating indicator light will be off.
If the kettle inside water temperature higher than chosen temperature, the kettle will give
two sounds and the keep warm indicator light flash. Display show the real temperature.
After the water temperature cool down to be chosen temperature, the indicator light will
stop flashing and be on . Display show the chosen temperature.
Reminder 1: Keep warm for two hours
Reminder 2: No Keep warm function at 100°C
Switch off
Touch "Boil/Cancel" button, kettle stop working, all indicator light off. The temperature
display will be off in 20mins.
Memory
The kettle have memory function under keep warm mode.
Take the kettle from the base, and put it back. If the water temperature with the range of ±
5°C of chosen temperature, Keep warm function still work.
Reminder: There is no memory function under cooking mode.
Fault
If there is no any indicator light or no digital showed on display when put the kettle on the
base, it might be :
1. No water in the kettle.
2. Too much scale stocked which start up the dry boil function.
You can take the kettle from the base, cooling for several minutes and fill the kettle with
cold water. Touch the ON/OFF again to start the kettle.
Cleaning
Always pull out the plug from the socket before cleaning!
The exterior of the machine should be cleaned, if necessary, with a slightly damp cloth
without additives.
Decalcification
• The frequency of the decalcify operation depends on the hardness of the water and on
how often the appliance is used.
8