Cleaning, Storage, Transport And Ordering Of Spare Parts - EINHELL GH-BC 43 AS Originalbetriebsanleitung

9.6 Setting the throttle cable
If the maximum speed of the equipment drops
over time and you have ruled out all the other
possible causes listed in section 12 „Troubleshoo-
ting", it may be necessary to adjust the throttle
cable. First of all check whether the carburetor
opens fully when the throttle handle is pressed
right through. This is the case if the carburetor sli-
de (Fig. 41) is completely opened when the thrott-
le is fully activated. Figure 41 shows the correct
setting. If the carburetor slide is not completely
open, it must be adjusted. The following steps are
required to adjust the throttle cable:
Undo the lock nut (Fig. 42/Item C) a few turns.
Turn out the adjusting screw (Fig. 42/Item D) until
the carburetor slide is completely open when the
throttle is fully activated, as shown in Figure 41.
Retighten the lock nut.
9.7 Setting the idling speed
Important! Set the idling speed when the equip-
ment is warm.
If the engine stalls when the throttle is not pressed
and you have ruled out all the other possible
causes listed in section 12 „Troubleshooting", the
idling speed must be adjusted. To do this, turn
the idling speed screw (Fig. 42/Item E) clockwise
until the equipment runs smoothly at idling speed.
If the idling speed is so fast that the cutting tool
turns as well, it has to be reduced by turning the
idling speed screw for as long as is required for
the cutting tool to stop turning as well.
9.8 Applying grease to the gear unit
After every 20 hours of use add a little gear gre-
ase (approx. 10 g.) at the lubrication nipple (Fig.
28/Item 21).
Anl_GH_BC_43_AS_SPK7.indb 28 Anl_GH_BC_43_AS_SPK7.indb 28
GB
10. Cleaning, storage, transport and
ordering of spare parts
10.1 Cleaning
•
Clean the equipment as required with a damp
cloth and, if necessary, mild washing up
liquid.
Important!
Always pull out the spark boot plug each time
before carrying out any cleaning. Never immerse
the equipment in water or other liquids in order to
clean it.
Store the chainsaw in a safe and dry place out of
the reach of children.
10.2 Storage
Important: Never put the equipment into storage
for longer than 30 days without carrying out the
following steps.
Storing the equipment
If you intend to store the equipment for longer
than 30 days, the equipment must be prepared
accordingly. Otherwise the fuel still remaining in
the carburetor will evaporate and leave a rubbery
sediment. This can cause problems when starting
up the equipment and may require expensive
repairs.
1. Slowly remove the fuel tank cap to release
any pressure that may have formed in the
tank. Carefully empty the tank.
2. To remove the fuel from the carburetor, start
the engine and let it run until the equipment
stops.
3. Leave the engine to cool (approx. 5 minutes).
4. Remove the spark plug (see section 9.4).
5. Add one teaspoon of 2-stroke engine oil into
the combustion chamber. Slowly pull the star-
ter cord several times to apply a layer of oil
to all internal components. Fit the spark plug
again.
Note: Store the equipment in a dry place and
far away from possible ignition sources such as
an oven, a gas-fi red hot water boiler, a gas-fi red
dryer, etc.
- 28 -
11.06.13 10:19 11.06.13 10:19