Functional Description - Makita DUB142 Betriebsanleitung

2. Never point the nozzle at anyone in the vicinity
when using the blower.
3. Warning - Electric shock could occur if used on
wet surfaces. Do not expose to rain. Store
indoors.
4. Never block suction inlet and/or blower outlet.
• Do not block suction inlet or blower outlet to
clean up in dusty areas.
• Do not use the blower with a tapered nozzle
smaller than the original one, such as a new
nozzle obtained by attaching an extra diameter-
reduced hose or smaller hose to the nozzle top
end.
• Do not Use the blower to inflate balls, rubber
boat or the similar.
Increased motor revolution may cause dangerous fan
breakage and result in serious personal injury. Heated
motor and control circuit may cause a fire.
5. Keep children, other bystanders and pets away
from the blower while operating.
6. Do not operate the blower near open window, etc.
7. Operating the blower only at reasonable hours is
recommended - not early in the morning or late at
night when people might be disturbed.
8. Using rakes and brooms to loosen debris before
blowing is recommended.
9. It is recommended to slightly dampen surfaces in
dusty conditions or use mister attachment
available on the market.
10. It is recommended to use the long nozzle so the
air stream can work close to the ground.
11. The blower is not intended for use by persons with
reduced physical, sensory or mental capabilities,
or lack of experience and knowledge.
12. Young children should be supervised to ensure
that they do not play with the blower.
13. Do not insert fingers or other objects into suction
inlet or blower outlet.
14. Always use the dust bag when collecting dust,
chips and the like.
15. Do not collect still smoldering cigarette ashes,
freshly cut metals shavings, screws, nails and the
like.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
follow the safety rules stated in this instruction
manual may cause serious personal injury.
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter,
stop operating immediately. It may result in a risk
of overheating, possible burns and even an
explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1)
(2)
(3)
A battery short can cause a large current flow,
overheating, possible burns and even a
breakdown.
6. Do not store the tool and battery cartridge in
locations where the temperature may reach or
exceed 50°C (122°F).
7. Do not incinerate the battery cartridge even if it is
severely damaged or is completely worn out. The
battery cartridge can explode in a fire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
SAVE THESE INSTRUCTIONS.
Tips for maintaining maximum battery life
1. Charge the battery cartridge before completely
discharged.
Always stop tool operation and charge the battery
cartridge when you notice less tool power.
2. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3. Charge the battery cartridge with room
temperature at 10°C - 40°C (50°F - 104°F). Let a hot
battery cartridge cool down before charging it.
4. Charge the battery cartridge once in every six
months if you do not use it for a long period of
time.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
(Fig. 1)
• Always switch off the tool before insertion or removal of
the battery cartridge.
ENC007-7
• To remove the battery cartridge, withdraw it from the
tool while pressing the buttons on both sides of the
cartridge.
• To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Always insert it all the way until it locks in
place with a little click. If not, it may accidentally fall out
of the tool, causing injury to you or someone around
you.
Do not touch the terminals with any
conductive material.
Avoid storing battery cartridge in a container
with other metal objects such as nails, coins,
etc.
Do not expose battery cartridge to water or
rain.
5