Refill Fuel; Water Connection; Suck In Water From Vessel - Kärcher HDS 5/13 U Bedienungsanleitung

Install hand spray gun
 Connect ray tube with hand spray gun
 Mount the nozzle on the spray lance
(markings on the adjustment ring at the
top).
 Appliance without hose drum:
Connect the high pressure hose to the
high pressure connection point of the
machine.
DANGER
Risk of explosion! Only refill diesel oil or
light fuel oil. The operation with bio diesel
as per EN 14214 (starting at an outside
temperature of 6 °C) is possible. Unsuita-
ble fuels, e.g. petrol, are not to be used.
ATTENTION
Never operate device with empty fuel tank
The fuel pump will otherwise be destroyed.
This also applies to cold water operation.
 Open fuel filler cap.
 Refill fuel.
 Close tank lock.
 Wipe off spilled fuel.
Operation with detergent
DANGER
Risk of injury!
– Use Kärcher products only.
– Under no circumstances vacuum sol-
vents (petrol, aceton, diluting agent
etc.).
– Avoid eye and skin contact.
– Observe safety and handling instruc-
tions by the detergent manufacturer.
Kärcher offers an individual cleaning
and care appliances program.
Your dealer will consult you gladly.
 Fill/replace external detergent contain-
er.
20

Refill fuel

Water connection

WARNING
Observe regulations of water supplier.
According to applicable regula-
tions, the appliance must never be
used on the drinking water net
without a system separator. En-
sure that the connection of your building
water installation on which the high-pres-
sure cleaner is operated is equipped with a
system separator pursuant to EN 12729
Type BA.
Water that was flowing through a system
separator is considered non-drinkable.
CAUTION
Always connect the system separator to
the water supply, never directly to the appli-
ance!
For connection values refer to technical
specifications
 Attach supply hose (minimum length
7.5 m, minimum diameter 1/2") to the
water supply set by means of a hose
clamp.
 Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note: The supply hose and the hose clamp
are not included in the scope of delivery.

Suck in water from vessel

 Connect suction hose (minimum diame-
ter 1/2") with filter (accessory) to the
water connection point.
– Max. suck height: 0.5 m
DANGER
Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, ex-
plosive and poisonous.
– 4
EN